DMX MArquee W610 Spezifikationen PDF herunterladen (Seite 8)

Page | 8

3. Out of the box, the W610 defaults to operate from a wired network connection. If performing a

wireless setup, you will need to know the following information in advance of performing

configuration:

– SSID

– Encryption Key Type (e.g., WEP/WPA)

– Passphrase type (ASCII/Hex). If this is unknown, and the key contains

only the letters A-F and numbers, it is most likely a Hex key.

– Passphrase or Key

After obtaining this information, please follow the instructions later in this document under

Wireless Installations.

4. The default network configuration uses DHCP to acquire a network address. If a static IP

address if preferred or required, follow the instructions later in this document.

step by step instructions

Identify a discreet location for placement of the media player. Ideally, it should have limited access

and be near an existing network port to the public Internet. A network/phone closet, manager‟s

office or other secure location is recommended. Place the media player in a location near the

dedicated power source, the available network port, and where at least 3” of airflow is available

around the unit. The media player may be mounted on its side if necessary.

Confirm availability of a dedicated (non-switched) power source. The media player receives

content and software updates overnight. It should not be powered by a source that is turned off at

any time. A surge suppressor with COAX suppression is recommended.

Note that standard broadband Internet access is required. In addition, HTTP, HTTPS and SFTP

ports (80, 443 and 22, respectively) should be enabled.

Recommended Step: Using a laptop (or other network device), connect to the existing network

and confirm that marquee.dmx.com can be pinged. If it is not accessible, network connectivity

must be corrected prior to proceeding.

Connect one end of the included Ethernet patch cable to the existing host network port.

Connect the other end of the Ethernet patch cable to the RJ-45 Ethernet port on the rear of the

media player.

If a wireless network is being utilized, connect the wireless antenna to the antenna post on the rear

of the media player.

Connect the appropriate cables from the video screen to the appropriate connector on the rear of

the media player. The screen must be connected and powered on prior to powering the media

player.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Keine Kommentare

DMX MArquee W610 Spezifikationen Seite 8