DMX MArquee W610 Spezifikationen Seite 18

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 30
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 17
Page | 18
Marquee Technical Guide - Version 6.3.9 040511 DMX ©2010 All Rights Reserved
installing video pass-thru (standard definition) using the Hauppauge
HVR-1950
Run the necessary cable (Coaxial RF, S-Video or Composite) from the video source to the
media player.
Verify the source video using this cabling.
Power down the digital media player.
Connect the Video Adapter to any available USB port on the media player. Note that ideally it
should be connected to a port where it is not likely to be bumped or disconnected.
Determine the connection to the video source (Coaxial RF, S-Video or Composite). Note that
multiple sources may be installed as long as each uses a separate connection. For example, a
cable tuner may be connected using S-Video while a surveillance camera is connected using
Composite.
Determine the aspect ratio of the output source. Determine if output source is standard (4:3),
standard (16:9) or high definition (16:9).
Connect the video source(s) to their respective connector on the Video Adapter (Coaxial RF) or
cable adapter (S-Video and/or Composite).
Turn power on to (1) the video source(s); (2) display(s); (3) media player.
Instruct the client which device (e.g., HVR-1950) and connection(s) was/were used during the
installation. If Coaxial cable is used, instruct the client that the source video output channel
should be set to 3. Instruct the client what the aspect ratio of their output source is. It is critical
the client knows which connection and channel (where applicable) is assigned to each source,
as they will need to identify this when programming the media player for playback.
NOTE: If the client requires a channel other than Channel 3, a separate channel tuning device
is required, or channels may be changed via the Marquee site. Remote controls are not
supported on the W610 player.
If the video pass-thru content does not fill the entire video zone (e.g. black on the top and/or the
bottom, or the sides), call technical support at 800-345-5000 to resize the video zone remotely.
Seitenansicht 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

Kommentare zu diesen Handbüchern

Keine Kommentare